DAS NX-148E LCD Codepad Instrukcja Instalacji Pobierz pdf (Strona 26)

Dialer Options (Features 4 – 11)

Feature 4 Phone Number One (1)

Segments 1-20

14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14

The first telephone number is programmed in Feature 4.

’15’ = pulse dialling - in the segment where pulse dialling should begin

’14’ indicates the end of the phone number. Fill all empty segments after end of dialling with ‘14’

’13’ = four second delay - in the segment where a delay is required

’12’ = a ‘#’ - in the segment as required

‘11’ = for a ‘’ - in the segment as required

Feature 5 new System Account Code

Segments 1-6

10 10 10 10 Reserved new Reserved new

This is the account code sent for any area event (open/close and zone related alarms) that does not have its account code

programmed. System events (siren/box tampers, expander troubles, etc.) will use the system account unless area one

account is programmed.

Feature 6 Communicator Format

Segment 1

Feature 6 contains the communicator format used. Select a format from the format selection table. If this feature contains a

‘0’, the built-in communicator will be disabled, and the panel will function as a local only control.

Data Communicator Format

Local

Communicator is disabled

Contact I.D.

DTMF format for control rooms

Pager

Reports in 4 + 2 DTMF format. Phone numbers can be programmed via code pad in normal

operation.

Domestic Siren

Domestic dialling via a siren tone format. Call can be kissed off via the star () key on a DTMF

phone. Phone numbers can be programmed via code pad in the run mode.

Feature 7 Phone Number Two (2)

Segments 1-20

14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14 14

The second telephone number is programmed in Feature 7.

’15’ = pulse dialling - in the segment where pulse dialling should begin

’14’ indicates the end of the phone number. Fill all empty segments after end of dialling with ‘14’

’13’ = four second delay - in the segment where a delay is required

’12’ = a ‘#’ - in the segment as required

‘11’ = for a ‘’ - in the segment as required

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 87 88

Brak uwag

DAS NX-148E LCD Codepad Instrukcja Instalacji Strona 26